Axis Communications T8123-E Mode D'emploi page 6

Page 6
Mounting Instructions
The AXIS T8123-E/T8124-E may be wall or bench mounted using the rear side holes.
Note the following before mounting the AXIS T8123-E/T8124-E to a fixed location:
• Do not cover the midspan or block the airflow to the product with any foreign object. Keep
the midspan away from excessive heat and humidity, and free from vibration and dust.
• Ensure that the cable length from the Ethernet network source to your Axis video product
does not exceed 100 meters (333 ft). The midspan is not a repeater and does not amplify
the Ethernet data signal.
• There is no "on-off" switch; simply plug the AXIS T8123-E/T8124-E into an
AC power outlet.
To mount:
1. Fasten the AXIS T8123-E/T8124-E with three screws. See Fig 1 (screw holes are marked1,2,3)
2. Connect one end of the grounding wire to EARTH GROUND (see fig 1b) and the other end to an
appropriate ground location.
Note: When mounting the AXIS T8123-E/T8124-E make sure to use appropriate screws and plugs
for the surface (wood, concrete etc.). Do not unscrew the four pre-mounted screws
located in every corner of the product.
46.36
Fig 1
1
2 3
AXIS T8123-E/T8124-E Users Guide
Fig 1b
EARTH GROUND