Matco Tools MT2887A Instructions De Fonctionnement page 3

FEATURES
• High performance efficient 1/2 HP motor for extra torque and extended durability
• Ideal for polishing and grinding jobs with all size pads
• Industrial cut gear design for extra long life and quiet performance
• Special angle head design for more clearance while doing limited access work
• Positive stop regulator for more versatile performance on all kinds of jobs
• Super comfortable safety throttle lever to prevent accidental start ups
OPERATION
Always turn off the air supply, drain hose of air pressure
and detach tool from air supply before installing, removing or
adjusting any part or accessory on this tool, or before performing
any maintenance on this tool.
Bonded abrasive mounted point grinding wheels, rotary files
and carbide burrs can be mounted providing their speed rating
exceeds the speed of the Grinder. The shank size of the mounted
accessory must match the collet size fitted in the Grinder. Insert
the shank of the mounted point as far as possible into the collet
and tighten the nut using the supplied wrenches. Minimum shank
gripping length must be 10mm.
After mounting a new point, start the Grinder under bench and
run for a few seconds. If the Grinder starts to vibrate when first
fitting a mounted point or during operation, immediately remove
from service. If Grinder is dropped, replace grinding wheel,
rotary file or carbide burr.
When using the Grinder, be careful not to exert excessive force
which could be hazardous and cause mounted spindle to bend
or break.
NOTE: During operation, safety goggles should always be worn
to guard against flying rust and chips (users & bystanders).
MT2887A
MT2887A .50 HP 115˚ Angle Die Grinder
3 02/06/15