Sunex Tools 1003AJ Manuel D'opération page 3

Saddle
Saddle Column
Locking Holes
Locking Pin
Support Column
ASSEMBLY INSTRUCTIONS
1 . Install the support column into the stand base, align the holes in the stand base with the holes at the bottom of the support column .
2 . Install the bolt through the stand base and support column and thread the nut onto the bolt and tighten .
3 . Place the saddle column into the support column .
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards . Obey all instructions to avoid possible injury or death .
1 . Make sure the work floor is clean and free of debris and obstacles .
2 . Chock the vehicle's tires that will not be lifted . Make sure the emergency brake is on and the vehicle's transmission is either in the park
mode or in gear if a manual transmission .
3 . Raise the vehicle to a safe working height and make sure the jack and vehicle setup are stable before positioning the jack stands . DO
NOT CRAWL UNDER THE VEHICLE TO POSITION OR REMOVE STANDS.
4 . Position the jack stands right below the areas of the vehicle support points as specified by the vehicle manufacturer .
5 . Lift the saddle columns as close to the vehicle as possible without the saddles on the columns coming in contact with the vehicle .
Insert the locking pin .
6 . Slowly and carefully lower the vehicle on the jack stands . Shock loads or loads dropped abruptly on stands can cause premature metal
fatigue or even stand failure depending on the weight of the vehicle and the speed of decent that impacts the stands' support columns .
The load should be supported in the center of the support column saddles, not the locating lugs of the saddles . DO NOT CRAWL UNDER
THE VEHICLE TO POSITION OR REMOVE STANDS.
7 Check the load for stability . If the load is not stable, lift the load off the stands and correctly reposition the stands .
8 . When work is completed, raise the vehicle high enough off the stands where the stands can be easily removed .
1003AJ
Hole
Saddle Column
Locking Pin
Chain
Stand Base
Bolt and Nut
3
MODEL 1003AJ
CAPACITY: 3 TON
JACK STAND (PAIR)
Locking Pin
rev . 1/13/20