Napa 6-1023 Guide D'utilisation page 3

AIR SUPPLY
Tools of this class operate
on a wide range of air
pressures. We recommend
that air pressure measures 90
PSI at the air inlet while in
use. Low pressure (less than
90 psig/6.2 bar) reduces the
speed and performance of all
air tools. High pressure (over
5 psig/8.0 bar) exceeds the
rated capacity of the tool,
which will shorten tool life
through faster wear and
could cause injury.
Always use clean, dry air.
Dust, corrosive fumes, and/
or water in the air line will
LUBRICATION
Lubricate the air motor daily
with NAPA air tool oil. If no
air line oiler is used, run
/2 oz. of oil through the
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE ThIS mANUAL fOR fUTURE REfERENCE.
6-1023
cause damage to the tool.
Drain the air tank daily.
Clean the air inlet filter
screen at least once per
week.
Throttle
tool. The oil can be sq­uirted
into the tool air inlet or into
the hose at the nearest
connection to the air
3
The air inlet used for
connecting the air supply
has standard /4" NPT
American Thread. Line
pressure should be increased
to compensate for unusually
long air hoses (over 25 feet).
Air Inlet
Minimum hose diameter
should be 3/8" I.D. Fittings
should have the same inside
dimensions and should be
tightly secured.
Speed
Regulator
supply, then run the tool.
Overfilling will cause a
reduction in the power of
the tool.
Rev. 10/24/07