Symmons Identity SLC-6710-1.5 Manuel D'utilisation Et D'entretien page 4

Installation
7) Attach supply lines to IPS inlet
connections (I). Using a wrench,
finish with one half turn. DO NOT
overtighten.
1
1
Maintenance
1) Turn off water supply. Loosen and
remove the handle set screw (B),
handle (A), collar (C) and nut (D).
A
2
3
C
D
4
Troubleshooting Chart
Problem
Finish is spotting.
Symmons Industries, Inc.
Copyright © 2016 Symmons Industries, Inc.
8) Attach supply lines to shut-off valves
and hand tighten. Using a wrench,
finish with one-half turn. DO NOT
overtighten.
1
I
2
2) Remove cartridge (F, G) and inspect
for debris. Replace cartridge if
necessary.
B
Elements in water supply may cause
water staining on finish.
■ ■
31 Brooks Drive Braintree, MA 02184
■
symmons.com
1
2
F G
Cause
■
Phone: (800) 796-6667
■
gethelp@symmons.com
9) Turn on water supplies. Remove
aerator (H) and flush lines free of
debris. Check for leaks.
3) Install cartridge following steps
1 & 2 in reverse.
Solution
Clean finished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
■
Fax: (800) 961-9621
■ ■
ZV-3205 REV 0 050216
H