oneConcept LUZERN Mode D'emploi page 11

• Press PLAY/PAUSE to start playing tracks from the USB / SD card. Press again to stop
playing USB / SD operation temporarily. Press again to resume playback.
• Press SKIP/PREVIOUS to skip to the next track, respectively go back to previous track.
Hold for fast forward/fast rewind.
• Press STOP to stop all USB/SD operation.
• Plug or slot in USB / SD card device to the port.
• Press the "FUNCTION" button to select "USB" mode or "SD" mode.
• The LCD will display "READING" while the stereo scans for MP3 from the USB / SD device.
• The LCD will display the total number of the folders of MP3 files and start the playback
automatically.
• Press the "PLAY / PAUSE" button again, when you want to stop playback temporarily.
• Press the "PROG. / STOP" button when finished.
Repeat function: Press the "MODE" button on the remote during playing USB / SD card
•
repeatedly to cycle through the repeat modes REPEAT 1 - REPEAT ALL - REPEAT OFF.
• Select Aux mode to listen to external audio devices connected through the 3.5mm Auxiliary
Stereo Line-In jack. Press FUNTION to select "LINE" mode. In "LINE" mode, the display will
show back to the normal time and calendar display.
• Use a 3.5mm Male-to-Male Stereo cable to connect any external audio device with a
3.5mm Headphone or Line-Out jack to the AUX IN jack on the rear panel of the stereo.
• Start playabck on the external audio device. Adjust the volume on the audio device (do
not set the volume too high to avoid distortion). You may also adjust the volume on the
appliance.
• To control playback function, use the controls provided by the external audio device.
Automatic tuning
• Press the "FUNCTION" button to select "RADIO" mode.
• Press the "MODE" button to select AM or FM.
• Press and hold the "SKIP +" or "SKIP -" button over 3 seconds to start automatic tuning
process.
• When a station is tuned in the tuning process, it will stop automatically and you can listen
to your desired station.
Operation
Basics
USB/SD
AUX
Radio
11