Télécharger Imprimer la page

Dandy DPAC7008 Manuel D'utilisation page 4

Publicité

Les langues disponibles

Les langues disponibles

Electrical Specifications
1. Check available power supply and resolve any
wiring problems BEFORE installation and opera-
tion of this unit. All wiring must comply with local
and national electrical codes and be installed by
a qualified electrician. If you have any questions
regarding the following instructions, contact a
qualified electrician.
2. This appliance draws 6.5 nameplate amps under
Cooling Mode and may be used in any properly
wired, general purpose 15 amp household
grounded receptacle.
3. For your safety and protection, this unit is
grounded through the power cord plug when
plugged into a matching wall outlet. If you are
not sure whether the wall outlets in your home
are properly grounded, please consult a qualified
electrician.
WARNING! : Improper connection of the ground-
ing plug can result in a risk of; Fire, Electric
Shock and/or Injury to Persons associated with
the Appliance. Check with a qualified electrician
or service representative if you are in doubt that
the appliance is properly grounded.
4. DO NOT USE PLUG ADAPTERS OR REGULAR
EXTENSION CORDS WITH THIS UNIT. If it is
necessary to use an extension cord with this
unit, use an approved "air conditioner" extension
cord only (available at most hardware stores).
5. To avoid the possibility of personal injury, always
disconnect the power supply to the unit, before
installing and/or servicing.
Important Safety Instructions
The power cord supplied with this air conditioner
contains a current leakage detection device
designed to reduce the risk of fire. Please refer to
the section "Power Supply Cord" for details. In the
event the power supply cord is damaged, it cannot
be repaired it must be replaced with a new cord
from the Product Manufacturer.
• Under no circumstances should this device be
used to turn the air conditioner on or off.
• The 'RESET' button must always be pushed in
(engaged) for correct operation.
• The power supply cord must be replaced if it fails
to reset when the 'TEST' button is pushed in.
• If the power supply cord is damaged, it cannot
be repaired. It must be replaced with a new cord
obtained from the Product Manufacturer.
Tf
Power Supply Cord
The power cord supplied with this air conditioner
contains a device that senses damage to the power
cord. To test if your power supply cord is working
properly, you must do the following;
1. Connect the power supply cord to an electrical
outlet.
2. The power supply cord is inclusive of two buttons
located on the head of the plug. One button is
marked 'TEST', the other button is marked
'RESET'. Press the 'TEST' button, you will hear a
click as the 'RESET' button pops out.
3. Press the 'RESET' button, you will hear a click as
the button engages.
4. The power supply cord is now energized and
supplying electricity to the air conditioner. (On
some products this is also indicated by a light on
the plug head).
Suggested Individual Branch Circuit
Nameplate Amps
6.5
AWG- American Wire Gage
* Based on copper wire at 60°C temperature rating.
Receptacle and Fuse Types
Rated Volts
Amps
Wall Outlet
Fuse Size
Time Delay Fuse
(or circuit breaker)
CAUTION
Do not leave this unit unattended in a space
where people or animals who cannot react to a
failed unit are located. A failed unit can cause
extreme overheating or death in such an
enclosed, unattended space.
3
Table 1
AWG Wire Size*
14
Table 2
125
15
15
Plug Type

Publicité

loading