GAUI 500X-S Notice D'emploi page 31

Page P.4
Upper figure:
Connect the three motor connection lines to the connection lines of the speed controllers.
Important!
Connect the cables/plugs of the same colours for motors 1 and 3.
Swap the red and black cable/plug of motors 2 and 4 so that the motors rotate in opposite directions.
For the precise motor assignment, see the lower figure on page P.7. Label the individual motor gondolas with numbers
1 - 4 (also see top figure on page P.6).
Lower figure:
To easily insert the speed controller into the boom tube, apply a little lubricant to the shrink hose of the speed controller.
When pushing in the boom tube, observe that the groove in the tube is aligned laterally. Push the boom tube into the motor
gondola to the stop. The motor gondola pin then interlocks with the groove so that the motor gondola boom tube cannot
turn.
Page P.5
Upper figure:
When the boom tube is pushed into the motor gondola correctly, tighten the motor gondola screws and the motor attachment
screws.
Then insert the lower motor gondola cover and push the cover flap onto the holding pin for the safety ring.
Lower figure:
The manufacturer offers the quadrocopter 500X without a drive set as well and therefore has included a note regarding the
drive set of the Quadrocopter 330X-S into the assembly instructions of the 500X:
If you use the motors and the 10 A speed controllers of the GAUI quadrocopter „330 X-S", the power connections of the
speed controllers must be extended. You may do this on your own or by using an optionally available extension cable with
the GAUI number: 222170.
For motors 1 and 3, the cables of the same colour must be connected. Swap the red and black cables of motors 2
and 4 so that the motors rotate in opposite directions. The plug connections then must be secured with an adhesive stripe.
Page P.6
Upper figure:
The figure shows the four installed boom arms with the label 1 - 4.
Lower figure:
Put the central frame on the table according to the figure so that the grooved opening in the cover plate („mark") points to
the right (in model flight direction).
Push the boom arm with number 1 into the two circular boom holders from the lower right.
Important!
Observe that the pin of the inner boom holder interlocks precisely with the boom tube groove. The resulting slight
slant of the motor shafts by approx. 6° is intended and not a processing error of the boom tubes.
All manuals and user guides at all-guides.com
31