Work Light; Maintenance - Bell INFLATION STATION 500 Instructions D'utilisation

9. Push the inflator power button to turn on inflator. See #1 in figure 1. The INFLATION STATION™
500 will now inflate your inflatable item. Carefully monitor the pressure gauge to avoid over-
inflation. See #2 in figure 1.
10. Once the desired pressure has been reached, stop the inflator by pushing the inflator power but-
ton to the off position. See #1 in figure 1.
11. Wait several moments as air hose and nozzle may naturally heat during inflation. Then, remove
air hose nozzle from inflatable, remove adapter needle from air hose nozzle by turning the adapter
needle counterclockwise, and return the adapter needle to its storage location on inflator.
12. Unplug inflator from vehicle 12 Volt cigarette lighter socket.
13. Turn off vehicle.
USING THE LED WORK LIGHT:
The LED work light turns on when inflator unit is plugged into vehicle 12 Volt cigarette lighter socket.
1. Your INFLATION STATION™ 500 has a replaceable fuse providing maximum
protection for the inflator and/or your vehicle. See figure 3 for fuse replacement
instructions.
Adapter Body
2. Regularly check inflator air hose, 12 Volt cord and adapters for damage.
3. Keep the inflator dry, clean and free from oil and grease. Always use a clean cloth
when cleaning.

MAINTENANCE

— FIGURE 3 —
12 Volt Adapter Fuse Replacement
Turn tip counterclockwise to unlock Fuse Adapter Body
Fuse (Replace with ACG glass 15 amp fuse only)
6
7059761