GO/ON AS 18-2 Mode D'emploi page 7

Anleitung AS 18-2 Go On:Anleitung AS 18-2 Go On
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for
the safety instructions.
2. Layout:
1: Torque adjustment facility
2: Bit holder
3: Forward / Reverse selector switch
4: On/Off switch
5: Battery pack
6: Battery charger
7: Pushlock button
3. Proper use
The cordless drill/screwdriver is designed for
tightening and undoing screws, as well as for drilling
in wood, metal and plastic.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Important information
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 3 to 5 hours.
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in faultless
03.05.2007
condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing in
walls.
5. Starting up
Charging the NC battery pack
1. Take the rechargeable battery pack out of the
handle, pressing the pushlock button at the side to
do so (Figure 1).
2. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket.
3. Plug the battery pack into the charging adapter.
The green LED will come on to indicate that the
battery pack is being charged. An empty battery
pack requires a maximum charging period of 3 to
5 hours. The temperature of the battery pack may
rise slightly during the charging operation. This is
normal. Important! It does not switch off
automatically when fully charged!
If the battery pack fails to become charged, please
check
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
return
the charger
the battery pack
to our Customer Service Department.
Timely recharging of the Ni-Cd battery pack is
recommended in the interest of long battery life.
Recharging is always necessary when you notice
that the power of the battery-powered
drill/screwdriver is decreasing.
Never allow the battery pack to discharge
completely. This will result in damage to the Ni-Cd
battery pack!
Adjusting the torque (1)
The battery-powered drill/screwdriver is equipped
with a 16-step mechanical torque adjustment facility.
The torque for a specific size of screw is selected
with the set-collar (1). The correct torque depends
on several factors:
on the type and hardness of material in question
15:15 Uhr Seite 7
GB
7