Publicité
Les langues disponibles
Les langues disponibles
3
Place the car seat into
stroller in the rear facing
position so that it is in full
contact with both the
stroller seating surface
and seat back.
NOTE: check car seat for
secure fit in stroller.
Rotate the leg
rest up until it
firmly contacts
the back of the
Carseat can be installed on the right or
left seating position but you will need to
move the outside strap to the opposite
side of stroller. ONLY one carseat can be
installed at a time.
To detach the split ring, slide infant car
seat strap off the D ring (3a) as shown
then re-attach the Split ring (3b) to the
webbing on the opposite side of
3 a
3 b
Summer™ stands behind all of its products. If you are not completely satisfied or have any questions,
please contact our Consumer Relations Team at 1-401-671-6551 or www.summerinfant.com/contact
Summer Infant (USA), Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-401-671-6551
© 2020 Summer Infant (USA), Inc.
attaching a car seat (continued):
4
Pull the two infant car seat straps out of their pockets
located under the padding in between the center of
seats and on the outside of stroller as shown.
Slide them under the Vehicle Belt Hooks on the
carseat and across the car seat and lock the buckle.
Slide the padded buckle guard over the buckle.
Avoid serious injury from falling or
sliding out. Always place the car seat
straps into the Vehicle Belt Hooks on
the car seat and raise the leg rest up
until it is in contact with the back of
the car seat in its locked in position.
car seat.
stroller.
Summer Infant Canada
200 First Gulf Blvd., Unit C
Brampton, Ontario, Canada, L6W 4T5
1-905-456-8484
WARNING
Vehicle
Belt Hooks
(varies by model)
NOTE: Car seat straps can be
stored in the pocket on side of
the stroller and under the
padding in-between the
two seats.
click!
pull
pull
tight!
tight!
To Remove.
Colors and styles may vary.
MADE IN CHINA.
D0000000809 9/20
Publicité
