Summer 3Dpac CS+ Mode D'emploi page 11

Use this section to
attach car seat
models:
• NEVER install Infant Car Seat without fastening it securely to the stroller with the provided car seat
straps. Car seat must be in rear facing position only.
• NEVER lift the stroller by infant carrier handle.
• Use only with Summer™ Affirm™ 335, Graco® SnugRide® Click Connect™ 35, Graco® SnugRide®
SnugLock® 35, Chicco® Keyfit® 30, Chicco® Fit2® and Baby Trend® Secure Snap Gear® 35 infant car
seats. Other car seats or carriers are not designed to fit this stroller frame and may result in serious
injury or death. NEVER use them as they have not been safety tested.
1
removing the wheels:
attaching a car seat:
WARNING
Each wheel has a
release tab. Pull the
release tabs out to
remove wheels from
frame.
2 Make sure seat is fully reclined.
11