Conceptronic CHDDOCK23E Mode D'emploi page 9

ENGLISH
You can insert a 2,5" or 3,5" SATA harddisk in the harddisk docking station. The pictures below show you
how you can insert the harddisk in the docking station:
After the harddisk is inserted, you can power the docking station with the power switch on the backside.
Set the powerswitch on the backside to 'I' (on).
USB: When the docking station is connected with USB to your computer, the computer will recognize
and install the harddisk automatically. If the harddisk contains a valid partition, it will be shown
as a removable disk in your 'Computer' window.
eSATA: If the eSATA connection on your computer supports hot-plug functionality, the computer will
recognize and install the harddisk automatically. If the harddisk contains a valid partition, it will
be shown as a removable disk in your 'Computer' window.
eSATA note: If your computer does not support hot-plug functionality, the harddisk will not be
recognized automatically. Reboot your computer with the docking station turned on to
allow detection of the harddisk during the boot process of your computer.
4. Inserting a harddisk
2,5" harddisk 3,5" harddisk
9