Putting Into Operation; Troubleshooting; Warranty; Environmental Protection - Reer EasyHeat Flex Notice D'utilisation

!
35 cm
20 cm
100 cm
11. Open the grey locking screw of the upper attachment tube and set the changing table heater to the desired
height using the telescopic rod. Ensure that a minimum distance of 100 cm to the changing table is observed.
Adjust the unit to the desired height by closing the locking screw.
12. Secure the cable by pushing it into the cable holders.
Note: For an installation with fewer than 5 feet (for example due to limited space), the user must ensure stability
of the changing table heater pedestal by other means. Never place a changing table heater with fewer than 5 feet
freely in a room.

Putting into operation

1. Insert the mains plug into the power socket (fig. 1)
2. Pull the pull cord (fig. 2) to switch the heater on. The heater has heat settings: 500 W.
3. Automatic shut-off is directly activated. After 10 minutes, the device is automatically switched off or it may be
switched off at an earlier point by pulling the cord again.
Switch-off if tilted
The unit has an automatic switch-off function if tilted. If the angle exceeds 25° (for example if the unit is mounted
on the ceiling), the power supply to the unit is cut. The unit switches back on automatically, when it is upright again.
14
Position the changing table heater in the
desired location, out of reach of children
and observing the specified minimum
distances. Ensure that the pedestal is
positioned securely on a level surface.
10

Troubleshooting

issue possible causes
• The power plug is not connected
No heat radiation despite heat
setting properly.
• The automatic switch-off function
(timer) is activated.
• The automatic tilt switch-off
function is activated, because the
angle of the heater exceeds 25°.
Heat radiation despite the Defective LED
indicator being switched off.

Warranty

Please retain your receipt, the user manual and part number.
Claims under warranty or under warranty commitments are to be processed by the dealer alone.
The technical specification, information and characteristics of the product described herein have been compiled
to the best of our knowledge and belief and are correct at the time of printing. Any information provided by
reer should be correct and authoritative. Nevertheless, reer does not accept liability for potential errors in this
document and reserves the right to make changes to the product design and/or specifications without prior notice.
Reproduction and disclosure of information contained in this copyright-protected document, in any form or by
any means - graphical, electronic or mechanical by photocopying, recording on tape or storage in a data retrieval
system - even in part, require prior written consent from reer.

Environmental protection

At the end of its life, this product must not be disposed of as normal domestic waste, but should
be recycled at a collection point for electrical appliances. Please see the relevant symbol on the
product, in the user manual and packaging. Materials can be recycled as specified. An important
contribution to the protection of the environment can be made by reusing the unit, recycling its
components or otherwise reusing old appliances. Please contact your local council to find out more
about an appropriate disposal centre.
remedial action
• Check the power plug.
• Turn the „Timer" to „Off" or switch
the unit off and then on again by
repeatedly pulling the pull cord.
• Ensure that the heater is level and
fixed to the wall or the pedestal
is upright.
Please contact the customer service
15