Items Delivered; Assembly - Reer EasyHeat Flex Notice D'utilisation

Items delivered

1 x
A B
1 x D
C
1 x
E 1 x F
1 x
H
J 1 x
1 x
K
12
5 x
1 x
3 x
G
1 x
I
1. Radiant heater with 1 tube
2. Light as indicator for "on"
3. pull cord for switching the
unit on/off
Assembly of changing table heater with pedestal
1. Insert the 5 feet (B) into the
2. Place the foot cover (C) on top.
foot connector system (A) as
shown in.
4. Fix the lower attachment tube in 5. Slide a cable holder (G) over the
position by inserting the plastic lower attachment tube.
screw (E) from below.
7. Fix the middle attachment tube into place using the supplied screw (H)
and a Philips screwdriver.
8. Slide the remaining cable holder (G) over the middle tube and connect
the upper attachment tube (I) to the middle attachment tube. Fix the
upper attachment tube in position using the supplied screw and a
Philips screwdriver.
9. Remove the assembly plate from the unit as shown in.
10. Place the changing table heater (J) on the pedestal and fix it in position
with the plastic screw (F).
3. Insert the lower attachment tube
(D) into the opening.
6. Connect the middle attachment
tube (H) with the groove to
the lower attachment tube as
shown in and turn the middle
attachment tube until the holes
in both tubes align.
13