Publicité
Assembly instruction / Notice de montage
Double door coordinator 6000 push side
Bandeau sélecteur 6000 côté poussant
Assembly for active leaves DIN right is described below. For active leaves DIN left, please proceed accordingly.
Attach the drilling template and choose corresponding drill holes depending on mounting situation. Drill the holes.
Drill the hole pattern according to the drawing.
1a-c
Insert the end caps into the active leaf slide rail (A) and into the passive leaf slide rail (P).
2
Insert the middle pieces into the active leaf slide rail (A) and into the passive leaf slide rail (P). The lugs on the middle pieces
3+4
have to point forwards and downwards!
Direct mounting
5a
Screw on the door closer mounting plates.
Mounting with adaptor plate
5b
Screw on the adaptor plates
Mounting with under-lintel angle
5c
Screw on the under-lintel angle
mounting plates
.
2
Mount the active leaf slide rail and the passive leaf slide rail.
6a-c
Fit the door closer.
7
After closing the valve for the closing speed,open the doors
8
Open the valve for the closing speed
9
Push the triggering block
10
Open the inactive leaf
11
reversal point where it will start moving into the opposite direction, the sliding block must be fixed with the pair of set screws
Move the triggering block until stop
12
the door frame is 2mm, otherwise use distance plates A or B. The maximum projection length of the door frame with distance
plates is 8mm, all other lengths on request.
Adjust the doorcloser as stated in the separate mounting instruction.
13
The maximum opening angle of the door leaves is approx. 105°, depending on the constructional condition and the
14
door thickness. In order to avoid damages on doors and / or door closers, please set a door stopper at the
maximum opening angle (active and passive leaf).
Determine dimension Ls in line with drawing
15
and trim
.
2
Push coupling sleeves as depicted onto the connecting rod
16
the rod ends
. Push the coupling sleeves over the rod ends and tighten grub screws
3
sleeves have to point downwards.
Determine dimension L
17
Attach the cover profile.
18
Functionality test SR
Open both doors approx. 60°, the active leaf has to remain open. The Passive leaf closes. The active leaf is only allowed to
close if the passive leaf reaches a closing angle of approx. 30°.
Attach the nylon clips
19
(optional), shorten if necessary
2
(optional), shorten the active leaf profile if necessary. Screw on the door closer
1
and close the doors in the correct order
1
to its stop in direction of the door centre. Push the follower
1
1
. The shifting block
will be moved by the sliding block
b
. Mount triggering angle at stop on the roll
1
. Cut connecting rod to length in line with said dimension Ls + 214 mm
1
acc. to drawing
. Cut the cover profile to dimension L
1
A
. Install the rubber stoppers
1
(DIN right / DIN left mirror image)
(DIN droite / DIN gauche inverser l'illustration)
.Screw on the door closer mounting plates
1
. Connect the arm to the sliding block
1
a
. Turn the connecting rod by 90°
1
. Clip on U-Cover
and pinion cover
2
3
.
2
.
2
against the sliding block.
2
. When the sliding block reaches the
. Important: maximum projection length of
2
.Push connecting rod between
2
. Attention: the screws of the coupling
4
- 6mm and deburr
.
2
A
.
4
.
3
.
2
13/14
Publicité
