Troubleshooting; Warranty; Ce Declaration Of Conformity; Environmentally-Friendly Disposal - Cub Cadet LH5 B60 Notice D'instructions Originale

Warranty

Risk of injuries or material damage
¾ In case of doubt always consult a service centre.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics)
is too high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
Warranty
The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactu-
ring defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.

CE Declaration of Conformity

Further details about the device are
contained on the separately enclosed CE
Declaration of Conformity, which forms part
of this instruction manual.

Troubleshooting

WARNING!

Environmentally-friendly disposal

Power tools, accessories and packaging must be
disposed of via an environmentally compatible
recycling chain.
Power packs/batteries:
Do not dispose of power packs/batteries
in domestic waste, by burning or throwing
into water. Power packs/batteries must
be collected, recycled or disposed of in
an environmentally-friendly manner.
Power tools (without power packs/batteries):
Do not throw your old power tool away with the
domestic waste. Take it to a suitable disposal
facility.
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device too cool and if neces-
sary, clean the air inlet.
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
heat up.
Replace the power pack.
EN
21