Aerotec Mobilpack 2 Manuel D'utilisation page 7

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Any continued loss of air after performing the above steps
indicates a problem with the safety valve. Discontinue use
and seek service before continued use of the air
compressor. If air leaks after the ring has been released
or if the valve is stuck and cannot be actuated by the ring,
do not use the air compressor until the safety valve has
been replaced. Use of the air compressor in this condition
could result in serious personal injury.
Do not at any time let brake fluids, gasoline, petroleumbased
products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury. Electric tools used on fiberglass material,
wallboard, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this
product for extended work on these types of materials.
However, if you do work with any of these materials,
it is extremely important to clean the product using
compressed air.
LUBRICATION
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
WARNING
English
TECHNICAL DATA
Maximum running pressure: 8 bar
Maximum working pressure: 6 bar
HP /W
0,4 / 300
The sound pressure level measured in a free range at a
distance of 4 mt. at the maximum working pressure.
The value of the sound level may increase from
1 to 10 dB(A) depending on the environment in
which the compressor is installed.
SYMBOLS
SYMBOL
RPM
4600
NAME
Safety Alert
CE Conformity
Please read the instructions
carefully before
starting the product.
Wear ear protection
Always wear eye protection.
Wear eye protection
Risk of injury. Do not direct air
stream at body.
Do not use compressed air for
breathing. Do not carry while
painting.
Risk of fire or explosion.
Risk of bursting.
To reduce the risk of electric
shock, do not
expose to rain. Store indoors.
Risk of electrical shock.
Hazardous voltage.
Hot surface: Risk of burn-Do not
touch!
Remotely start: The unit is
remotely controlled
and may start without warning.
Waste electrical products
should not bedisposed of with
household waste. Please
recycle where facilities exist.
Check with your local authority
or retailer for recycling advice.
DB(A)
92