Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
tips
• High ambient temperatures have a negative effect on energy use. Keep the appliance in a position away from direct sunlight or
other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as
soon as possible.
• The space between the shelves and the rear wall of the refrigerator compartment must be unobstructed to allow the cool air to
circulate. Therefore don't place any food items against the back.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
6
cleaning & maintenance
CLEANING THE LARDER
Frost settles on the rear wall of the cooling compartment. It is removed automatically. During the defrosting, the condensate,
which can contain contaminants may clog the water discharge opening. Should it occur, carefully unclog the water discharge
opening with the cleaning plug.
• Turn the thermostat off [OFF] and unplug the appliance.
• Open the door and remove the food. Keep the contents of the larder in a cool place and wrapped in blankets or newspapers.
• Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After cleaning,
rinse the interior with clean water and rub dry.
• Leave the appliance to dry for 1 to 2 hours. Simply remove the drawers, the glass shelves and the door compartments to clean
them by hand. Do not clean the interior accessories in the dishwasher.
• Clean the outside of the appliance and the gasket with a soft moist cloth.
• Switch the thermostat on to the right setting. When the larder reaches its correct temperature, replace the food items.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is blown, you can replace it
yourself.
7
troubleshooting
Problem
Appliance is not functioning;
light does not work
Temperature inside the
larder is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
20
•
English
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards
Publicité
Table des Matières
