Operation - Ener-G+ HEA-115J88 Gold Manuel D'utilisation

Installation:
1. Place the waterproof washer on the base and place the base cover on top. Screw 3 x M6*25 mm screws using
the Allen key through the waterproof washer holes and onto the base.
2. Place the heater right side up. Place the heater table top on the base and screw them together using the three 3
x M6*25 mm screws underneath the table top.
Make sure the heater is not connected to a wall outlet before placing it where it will be used.
NOTE: wait until the heater heating element has cooled down before moving it.
REMEMBER, portable electric heaters are designed for spot heating or as a supplementary heat source. They are not
intended to be the main source of heat during cold months.
Caution: 1)
If you must use an extension cord, the cord should be at least NO .14 AWG and rated for no less than
1875 W.
2) You must always make sure there is at least 6''/15 cm of empty space around the heater.

3. OPERATION

1) Turn the power button on the Heater panel control to activate or deactivate it.
P a g e | 2