Frico CFR1R 5 Notice De Pose Et D'entretien page 7

437 - Gruppo Comandi Frico:layout 1
the two fixing holes on the wall (Figures 1).
2) Drill the holes and fix the base (A) using the two screw anchors.
3) Insert (A) (through the two holes to be drilled) the leads that have to be
connected to the unit and power supply, making sure the length allows
their connection to the terminal board (Figures 1).
4) Fix (A) the intermediate wiring support (B) on the base using the screws
provided (Figures 1).
Connect the terminal board of the regulator in accordance with the
instructions provided in the diagram (Figures 2). Tighten the cables with
the screws and cable clamps provided.
5) Fix the intermediate wiring support (B) to the cover (C) using the screws
provided (Figures 3)
Operation (Figure 4)
1) Press key (D) (the pilot light turns on) to start the fan.
2) Turn the knob (E) to select the desired speed.
3) Reversibility: to select the orientation of the airflow (towards the floor or
ceiling), move the circuit breaker (G) to the desired position.
02/10/2007
7
17.52 Pagina 7