tGenot 3XL Manuel D'utilisation page 28

3 Filling in Water
4 ON/OFF
• You must fill in water before turning on the foot bath mas-
sager. Never try to operate this device without having water
inside the water container.
• Filling in water with water bucket. Do NOT put your mas-
sager under faucet directly.
• Be careful NOT to spill water onto the control panel.
• To save electricity or speed up water heating, you can put
in warm water but the warm water temperature should be
less than 40℃.
Water Level:
• The maximum water level is 70% of the water container or
to its maximum water level indicator.
• It
is recommended to fill in water up to 60% of water container
• Plug in power cord to wall outlet.
• Press ON/OFF button once to turn on power, the two-digit
LED display immediately shows the current water tempera-
ture inside the water container.
• Press the ON/OFF button again to turn off power complete-
ly.
• The default maximum water heating temperature is 35℃
once the power is turned on.
• Heating function is ON automatically if the current water
temperature is lower than its default 35℃.
.