Mercury 600.006 Mode D'emploi page 12

Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use
or disrespect of the warnings contained in this manual.
Mercury cannot be held responsible for personal injuries caused by a disrespect of the
safety recommendations and warnings. This is also applicable to all damages in whatever
form.
WARNING
To avoid possible electric shock or personal injury, follow these guidelines:
• Do not use the meter if it is damaged. Before you use the meter,
inspect the case. Pay particular attention to the insulation
surrounding the connectors
• Inspect the test leads for damaged insulation or exposed metal.
Check the test leads for continuity. Replace damaged test leads
before you use the meter.
• Do not use the meter if it operates abnormally. Protection may be
impaired. When in doubt, have the meter serviced.
• Do not operate the meter around explosive gas, vapour, or dust.
• Do not apply more than the rated voltage, as marked on the meter,
between terminals or between any terminal and earth ground.
• Before use, verify the meter's operation by measuring a known
voltage.
• When measuring current, turn o circuit power before connecting
the meter in the circuit. Remember to place the meter in series with
the circuit.
• When servicing the meter, use only speci ed replacement parts.
• Use with caution when working above 30V ac rms, 42V peak, or
60V dc. Such voltages pose a shock hazard.
• When using the probes, keep your ngers behind the nger guards
on the probes.
• Connect the common test lead before you connect the live test lead.
When you disconnect test leads, disconnect the live test lead rst.
• Remove the test leads from the meter before you open the battery
door.
• Do not operate the meter with the battery door or portions of the
cover removed or loosened.