FUJI ONKYO FLAGTV HD Notice D'utilisation page 6

Outside Antenna
1) Contents
Adapter + voltage injector
2) Technical data
Antenna
Band :
Gain :
Noise Factor :
Required power supply :
Polarization :
3) Installation
Before installing your TNT Antenna, select the location where it will be installed. Then make your connections and ensure that they
are operating correctly. Do not hesitate to move your antenna and change his orientation to obtain an optimum signal level. You
may mount the antenna on a wall, secure it to a beam, etc.
To fix your antenna using the mast attachment, slide "part 3" behind "part 1" and screw this one
on the antenna (into horizontal or vertical), insert the jaw (2) on the flange (3) and screw the
«part 4». With the flange and the jaw, you can also attach the antenna to a mast (up to a
50 mm diameter)
To attach your antenna using the wall mounting assembly,
screw first «part 1» on the antenna (horizontally or vertically)
and then mount on the wall with inserts.
You can install in two possible ways. In fact, the FLAG TV antenna must have a voltage of 5 - 24 Volts
applied to it to amplify signals. This voltage can be applied either by the TNT receiver (select «antenna
power supply : ON» in your receiver's menu) or by the supplied voltage injector. by a power presents
in the existing installation. In all cases, the injector could be put between the antenna and your device
6
(tele or receiving TNT) in order to control the level of signal.
Power supply :
Antenna
UHF (470 à 790 MHz)
40 dB
< 4 dB
5 Vcc to 24 Vcc 40 mA
Vertical and Horizontal
Mast attachment
Part 1 Part 2
x1
x1
Waterproof cap
Injector
Band :
Transit loss :
Power supply :
Part 3 Part 4
x2
x1
Screws
x4
40 à 862 MHz
3 dB (max.)
6 Vcc 100 mA
115 mm
Gain Control