Publicité
Les langues disponibles
Les langues disponibles
●
Before use, make sure hair is clean and tangle-free.
●
Fill the tank to your desired level with demineralized water.
●
Before use, remove yellow protec�ve film from the surface plates.
●
Plug in the Styler, press and hold the on-off switch un�l LED light
turns on.
●
Temperature bars flash un�l desired temperature is reached and
then the unit will beep when ready to use.
●
Run the Styler through the en�re length of the hair, without
stopping.
●
Repeat only twice per sec�on to prevent hair damage.
STEP 1:
Prep your hair. Make sure your hair is clean & tangle -free.
STEP 2:
The informa�on below is meant for persons with medium &
shoulder length hair. Take a 5 cm wide and 0,5 cm thick
sec�on of hair. Move the Styler over the sec�oned hair
star�ng at the roots about 0,5 cm away from the scalp. Run
the Styler slowly through to the ends of the hair with light
pressure.
STEP 3:
Repeat this process, sec�on by sec�on un�l your hair is
completely straight, so� and smooth.
5
Publicité
