E-MORE 1M2S Guide D'assemblage Et Mode D'emploi page 8

ENGLISH
TECHNICAL SPECIFICATIONS
1. Electric Components:
Input Voltage:
Duty cycle:
SAFETY AND WARNING!
This product can be used by children age 8 years and older, a persons with reduced physical, sensory or mental capacity as
long as they have been given proper instructions / training on how to use the product in a safe way and understand the haz-
ards involved. Children shall not play with the product.
CORRECT DISPOSAL
This sign indicates that this product must not be disposed through regular household waste within the European
Union. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. There you can obtain all
information necessary to dispose of this product properly. (WEEE-Reg.-Nr. DE: 52242201)
HANDSET
1. Up / Down Keys
To adjust the height of the desk, keep pressing the "up" or "down"
key until the tabletop reaches the desired position.
2. Display Screen
Display the height value of the desk.
3. Memory Key (1 / 2 / 3 / 4)
After setting memory keys, the desk will move automatically to the saved position.
How to set a memory key: Please select the desired position. Then press the S-key. Then press the S-Key, the display will show
a "S" and flashes. Whenever a programmed memory key is pressed, the tabletop will automatically adjust to the entered/
saved height.
4. Set Key
The set key saves all changed settings.
5. Anti-collision function
When the desktop encounters reverse resistance while moving, the desk will stop and move slightly in the opposite direction.
6. Re-set Procedure
1. When the display shows
frame rebounds slightly. Now the re-set is complete.
2. To force a re-set you have to move the frame to its lowest position by pushing the DOWN key. Release the DOWN key briefly
and push it again for about 5 seconds until you hear a "beep" and the frame rebounds slightly. The re-set is done.
To restore the factory settings (e.g., when a controller is replaced) press the UP and DOWN button simultaneously until you
hear a first "beep" after 5 seconds and a second "beep" after 10 seconds. Once the display shows "RST" proceed as described
under 1. Above.
8
100-240V, 50/60 Hz
10% max 2min on 18 min off
Automatic power off,
low energy consumption
press the DOWN key until the frame reaches its lowest position, you hear a "beep" and the
2. Desk Frame
Anti-Collission
Built-in load limit switch
Dynamic load: 60 KG
Static load: 80 KG max.
Speed: 25 mm/s
Up-/Down-
Display
Tasten
5-year
warranty
Memory Keys S-Key