Publicité
Les langues disponibles
Les langues disponibles
Opening the lid
Remove the kettle from the power base. If the switch button has been pushed
down inadvertently, it will spring up, into the "OFF" position.
Warning: if the water inside the kettle has just boiled, it will be full of steam, which
will escape as soon as the lid will be opened.
Hold the handle firmly in one hand, grip the lid knob in the other, and pull the lid
straight up. As soon as it separates from the kettle, move it out of the steam.
Filling
Wherever possible fill through the spout.
Watch the water level thanks to the water level indicator. You must use at
least one cup of water, but the water level must be below the Max. mark.
Do not overfill the kettle. If the kettle is overfilled, there is a risk that boiling
water may be ejected.
Switching on
Check that the switch is in the "OFF" position (lift the kettle from the power
base and set it down again).
Plug the power base into the wall socket. If necessary, switch the socket on.
Gently position the kettle on the power base, taking care not to spill any water.
Press the switch down. The switch will light up, and the kettle will start to heat
up.
When the water has been boiled, the kettle will switch off automatically, the
switch will return to the "OFF" position and the light will go out.
Switching off
If you need to switch the kettle off at any time before the water boils, simply lift
it from the power base and set it down again. The switch will pop up into the
"OFF" position.
GENERAL
When you lift the kettle from the base, you may see moisture on the surface of
the base. This is the steam used to switch the kettle off automatically, which
then condenses and is allowed to escape via vents in the underside of the
kettle. Do not lift it backwards, as this may allow water to pass through the
steam aperture on to the control area. Should this occur, the kettle must be
allowed to dry before use.
EN-6
Publicité
