Cata CTRS-50 REV SLIM Instructions Pour L'installation, L'utilisation, L'entretien page 33

Note: Please make sure to use the accessories provided by our company to
install this electric water heater. This electric water heater can not be
hung on the support until it has been checked that it is firm and reliable.
Otherwise, the electric water heater may face from the wall, resulting in
damage of the heater, even serious accidents or injuries to people.
When determining the locations of the bolt holes, it shall be ensured
that there is a clearance not less than 0.2m on the right side of the
electric heater, to facilitate the maintenance of the heater, if necessary.
1.
This electric water heater should be installed in a solid wall. If the strength
of the wall can't bear theweight equalling twice. The total weight of the
heater fully filled with water, it will be necessary to install a special support.
2. After selecting a proper location, determine the positions of the two installa-
tion holes used for expansion bolts with hook (determined according to the
specification of the product you select). Make two holes in the wall with the
right depth by drilling the correct size matching the expansion bolts
attached, insert the screws, place the hook upwards, tighten the nuts so that
they are firmly fixed, and then hang the electric water heater on it (see
Fig.2).
3. Install the supply socket in the wall. The requirements for the socket are as
follows: 250V/10A, single phase, three electrodes. It is recommended to
place the socket on the right above the heater. The height from the socket
to the ground shall not be less than 1.8m (see Fig.3).
L (
Brown)
N (Blue)
E (Yellow / Green)
≥1.8m
3
(Fig.2)