Trouble Shooting - Uzin Utz WOLFF PIRANHA 09 Mode D'emploi

2
6
5
7
Remove the power supply before
changing the blade! Unintended starting of the machine
may cause injury, e.g. of your hands.
01/2009 PIRANHA, #016927
5.3 Height adjustment
The height can be adjusted from 7 to 25 mm.
Loosen thumb screw ( 2 )
Adjust demanded high by switching the spine shaft with
the allen key ( 3 )
See scale ( 4 ) at the front side of the machine.
Before starting work, check the adjustment
5.4 Depth adjustment
The depth can be adjusted from 0 to 50 mm
Loosen lever screw ( 5 ) of the bit stop
Adjust demanded depth by moving and fixing the bit stop
( 6 ). Pull lever screw ( 5 ) tight again.
Before starting work, check the adjustment using a sample
piece.
5.5 Replacement of blade
If the quality of the cuts is getting worse, the blade has to be
changed.
Losen knurled thumb screw ( 7 ) and remove button blade
( 8 ) backwards.
Block motor gear with fixing device ( 9 ). Release flange
( 10 ) through bore hole by using hexagon socket screw
driver and clean flange. Remove used blade
Install new blade and fix flange
Reinstall the cover and pull knurled thumb screw tight ( 7 ).

6.0 Trouble shooting

Trouble Eventual cause
Machine does not start Power supply disconnected
fuse or cable
defective cable or plug
High expenditure of Blade is blunt
force necessary
High vibration Teeth of the blade are
broken of
Elimination
Have machine
repaired by a qualified
electrician
resp. change blade
Replace blade
Replace blade
12