Work Sequence - BEHAbelt RS02 Consignes D'installation Et Mode D'emploi

The appliance may only be connected to the input voltage specified on the name-
plate.
If the safety of the operator can no longer be guaranteed, the appliance must be
taken out of operation and secured against unintended use.
This is the case if the appliance:
· displays obvious damage
· no longer performs the desired functions
· was stored for too long under unfavourable conditions
During the welding process melted welding material can be thrown out of the ma-
chine. While operating the machine it is essential to wear safety glasses and protec-
tive long-sleeved clothes (danger of burns).
Use the machine only in large and / or ventilated areas.
Switch on the machine only when belt profile is clamped, otherwise the clamping
jaws can be thrown out of the holder.
Never use the product in an explosive area.
Never use the product in a wet area. Avoid the contact to the device directly with
water.
Repairs should only be performed by trained persons. Please send the product to
an authorized BEHAbelt service partner or directly to BEHAbelt.
This machine is not designed for continuous operation. Risk of motor over heating
and damaging of the machine.

3.3 WORK SEQUENCE

Please note the safety instructions and warnings in point 3.1!
Select and insert the clamping jaws (8). Remove adapter (9) for customised profiles
if required and insert the customised clamping jaws.
Driving jaws (8) apart and rotate the external hex (4) with a key to the left until the
clamping equipment engages.
Cut off both ends of the profile to be connected.
Insert the profile in the middle of the clamping jaws (8) and hold it tight with the
centre lever (5). Tighten the hexagonal head bolt (10) with the hexagonal socket
wrench. Repeat process for other side.
24