Publicité
Les langues disponibles
Les langues disponibles
GO TO VAPAMORE.COM TO SEE THE MR-750 OTTIMO INSTRUCTIONAL VIDEO
outlet. Allow steam cleaner to cool down before removing water tank cap. Unscrew the
water tank cap (Fig. 1) by pressing the cap down and simultaneously turning counter
clockwise. Check the water level with the supplied dipstick. Use the supplied funnel
Fill chart for working and heatimg times (water amount -working time - heating time):
700ml - 30-45min. - 5-7 min. / 1400ml - 60-80 min. - 10-12min. / 2100ml - 90-120 min.
- 15-17min. / 2800ml - 150-180min. - 20-22min. (Measuring cup has a 700ml full mark)
Fig.1
Do not ov
Fig.2
Status lights
On/off
switch
Replace the water tank cap by pressing down on the cap and simultaneously turning it
clockwise. Make sure the cap is fully tight to prevent any steam from leaking out. If
cap fully.
"on" position. The red status light will illuminate when the power switch is on indicating
the water is heating. The green status light will illuminate indicating the water is fully
Once the green light illuminates the steamer is ready for use. The green
!
light will cycle on and o as the heater turns on and o during use. Continue to use the
steamer as you normally would as the green status light cycles on and o .
Fig.3
_
+
Use steam controller
knob to adjust steam
OUTPUT
output level
FILLING & OPERATION
!
Tank
er
2800ml. If so drain excess water by removing the drain
fill cap
plug to achieve desired water level.
Dip
stick
4 marks, 100% - 2800ml, 75% - 2100ml, 50% -1400ml,
25% - 700ml. This allows options for working time and
heating wait time.
!
the cap while the steamer is hot can cause scalding
and severe burns.
!
increase the steam output and counter clockwise to
reduce the steam output.
Always use the dipstick to check the
Make sure steamer is completely cooled
Turn the controller knob clockwise to
(Fig.3)
The dipstick has
or
Publicité
