Assembling Your Iota Base; What's In The Box; Fitting The Holder And Stand; Adding A 2.5" Hard Disk Drive - Iota Tablets Iota Base Guide D'utilisation Et Garantie

ASSEMBLING YOUR IOTA BASE

What's in the box

Your iOTA BASE comes complete with:
11mm (x2)
10mm (x1)

Fitting the holder and stand

Follow these simple steps to assemble
your iOTA BASE:
A
Lay iOTA BASE faced down on a flat,
clean, non-abrasive surface (e.g. desk).
Remove cover, as shown above.
6
Keyboard
6mm (x2) 3mm (x4)
2.5" HDD holder (optional)
(x2)
(x4)
(x2) (x2)
iOTA BASE
(x4)
B
Place holder over 2 screw holes on
back. Tighten screws with cross-head
screwdriver.
(x2)
(x4)
C
Mouse
Once securely affixed, slide into stand.

Adding a 2.5" Hard Disk Drive

Your iOTA BASE does not require additional Hard Drive space to
function, but for users who require this option, follow the steps
shown below.
Important This is for fitting standard 2.5" HDD with SATA 3
interface connector.
(x4)
Remove back cover of HDD section.
Screw holder to 2.5" HDD before fitting to
your iOTA BASE using 4 screws.
Once HDD is fitted and connected with
ports, you're good to go.
D
(x2) (x2)
Replace cover removed in illustration A.
Your iOTA BASE is now ready to sit
(x4) (x4)
upright on your desk.
(x2)
A
Connect HDD to ports and screw into
place as shown above.
C
Replace cover you removed in
illustration A.
(x4)
B
D
7