Cooper Lighting MWS 0-10V Instructions D'installation page 2

Installation Instructions – MWS 0-10V Dimming
Starter Fitting/Starter Cable
Dimensional and Mounting Details
STARTER FITTING
Front
4-3/8"
[112mm]
Top
3/4"
[19mm]
Side
Starter (ST)
Converts conventional wiring to MWS. Branch circuits are fed from the panel to a junction box with conduit and wire. The Starter is mounted
to the junction box with a 1/2" threaded lock nut connector. Circuits are then connected to the appropriate leads of the Starter.
Starter Cables have 9', 15' or 21' of MC cable.
Fixture Cable
Dimensional and Mounting Details
1-7/8"
[47mm]
Front
4-3/8"[112mm]
5/8"
[16mm]
Fixture Cable (FC)
Feeds power to fixtures and allows circuits to be carried through to other fixtures. Locks into 1/2" KO of access plate, fixture body or
J-box. The unit adds 7/8" to overall height of the fixture.
Typical MWS Wiring System Application shown utilizing Fixture Cable (FC).
Extender Cables
Dimensional and Mounting Details
Front
1-7/8"
[47mm]
4-3/8"
[112mm]
5/8"
[16mm]
Extender Cable (EC)
Supplies power between MWS components. Cables connect together without use of couplers.
Typical MWS Wiring System Application shown utilizing Extender Cable (EC).
2
MWS IB519111EN Installation instructions
STARTER CABLE
Front
4-3/8"
[112mm]
Top
3/4"
[19mm]
Side
Front
4-3/8"[112mm]
Top
3/4"
Side
[19mm]
System View (not to scale)
Front
4-3/8"
[112mm]
Top
3/4"
[19mm]
Side
System View (not to scale)
Unit with no cable
Starter
Unit with no cable
Starter Cable
System View (not to scale)
Fixture Cable
Circuit T
Extender Cable
Drop SO Cord
Consult MWS Installation, Application and Specification Manual for
additional comprehensive system information.
Fixture Cable Extender or Fixture Cable
Fixture Cable Extender or Fixture Cable
Fixture Cable Fixture Cable
Quick Connect
Starter
Extender Cable
Switch Drop
Fixture Cable
Fixture
Extender
Cable
Cable
Fixture
Switch
Cable
Drop
Fixture Cable