Danby DDR4509EE Guide D'utiliser Et Soins De Propriètaire page 7

OPERATING INSTRUCTIONS (cont'd)
This dehumidifier is inclusive of a direct drain feature, located at the rear of the cabinet.
DIRECT DRAIN
NOTE: The drain hose is not included with the unit. The direct drain feature is intended
FEATURE
for use in basements inclusive of a floor drain only.
NOTE: Do not attempt to operate the direct drain feature using
drain/stem pipes above ground level.
CONNECTING THE DIRECT DRAIN:
1) Remove (cut away) drain cover located at the rear of the unit (see
Fig. 3) and remove the water tank located at the front of the unit.
2) Cut drain hose to required length (to suit your needs). You do not
need any fittings on either end of the drain hose. Insert one end of
garden hose directly into drain opening (see Fig. 4).
3) Push firmly onto the drain connector until it stops (see Fig. 5).
NOTE: This connection requires a pressure fit application only. Make
sure the hose is seated all the way back on the drain connection nipple.
4) Re-install the water tank, making sure the water full light turns
"off". If the light remains on, the tank has not been properly installed.
The water tank must always be installed inside the cabinet whenever
the direct drain option is being used.
5) Position the dehumidifier as close as you can to the floor drain.
6) Position the open end of the drain hose directly over the floor drain
and start the unit.
7) When the direct drain feature is not being used, remove the drain
hose from the direct drain nippe and plug the Direct Drain opening
(Fig. 3) with the rubber cap provided.
Fig. 3
Fig. 4
Fig. 5
6