Oster 078129-900-051 Manuel D'emploi page 7

5.
With the exception of grinding drum, sanding bands and sanding stone,
this Nail Grinder does not have user-serviceable parts. Any maintenance
not explained in this manual should be performed by an Authorized Service
Center.
Never clean Nail Grinder or replace bands/stone with motor ON.
To clean, remove Safety Guard and use compressed dry air to clean debris
from drum/stone/band area. Plastic housing and Safety Guard can be
easily wiped clean with a clean, damp (water) cloth.
NOTE: Certain cleaning agents and solvents can damage plastic parts. Use
only a water-moistened cloth when wiping plastic housing.
CAUTION: Cleaning and user maintenance shall not be made by children.
REPLACING SANDING BAND OR SANDING DRUM/SANDING STONE
For more information, refer to Before you Begin section of this
manual – Installing Drum / Changing Stone and Installing Sanding Band
on to Sanding Drum.
The following Nail Grinder replacement accessories are available through
your Oster
078129-110: Replacement Grinding Stone
078129-120: Replacement Grooming Bands (3 each of #60 grit and #100 grit)
078129-130: Replacement Grooming Drum
29-900_15EFSM1.indd 7
trimming a single nail all at one time. Continue to grind over edges
of nails to remove any roughness. Stop grinding when you get
close to the "Quick" (bloodline in nail). You will see the Quick begin
to appear when you look at the nail head on.
Turn Nail Grinder off by sliding switch to the center (OFF) position.
REPLACEMENT ACCESSORIES
authorized dealer:
®
MAINTENANCE
English-6
7/9/15 1:45