Télécharger Imprimer la page

Saris Cargo Accessory 4425 Instructions D'assemblage page 8

Publicité

Les langues disponibles

Les langues disponibles

EN
Technical Specifications
Accessory Tray weight: 31lb/14kg
Permitted cargo capacity: 120lb/ 54.4kg
CAUTIONS:
All requirements for compatability/fit as stated in the current Saris vehicle/carrier compatability guide must be followed. (Available at any Saris dealer or www.saris.com). If
your vehicle is not listed or you have any questions, please call our customer service at 800-783-7257 or visit www.saris.com.
Read and follow instructions carefully. Save owner's manual for future reference or parts information. Ensure that any other users of the bicycle carrier are familiar with their
content.
Drive slowly over speed bumps, 5 to 10 mph max speed.
It's the end users responsibility to ensure that use of this product meets all local and state laws.
When cleaning vehicle and rack, use only water soluble cleaners. Do not take rack through car wash.
Make sure bike tires are not directly behind exhaust pipe.
Rack must be installed directly into vehicle hitch receiver. Do not modify the hitch receiver or use hitch extenders.
Do not mount to any type of trailer or RV including Class B vehicles.
Prior to usage on the road, remove all loose parts from bicycle, including (but not limited to) child seat, basket, lock, light, pump, etc.
This carrier is not recommended for off-road use or for use at speed exceeding 70 mph (113 km/h).
The handling characteristics of a vehicle will change when a rear bicycle carrier is fitted and especially when it is loaded (in particular crosswind sensitivity, handling on
bends and braking). Driving techniques should be altered to allow for these changes, reduce speed, especially on bends and allow for longer braking distances.
The vehicle's total length increases when the bike carrier is attached. The bikes themselves may increase the vehicle's total width and height. Take care when reversing
and/or entering garages or ferries, etc.
Remove carrier from vehicle when not in use.
This carrier is constructed to carry standard-bike-frames. It is not intended for use with tandem or recumbent bicycles.
8

Publicité

loading