Publicité
Tab. 1
RIF.
SIGNAL
1
MAINS ON LED
2
HV1 ON/OFF SWITCH
3
HV1 LED
4
HV2 ON/OFF SWITCH
5
HV2 LED
6
HV3 ON/OFF SWITCH
7
HV3 LED
8
SERIAL/LOCAL-REM
I/O SWITCH
Ion Pumps Control Unit (No Battery) User Manual / 87-900-116-01 (E)
DESCRIPTION
When On it means that the unit is connected to the Power Line and the
Line Switch on the rear panel is in ON (I) position.
When in ON (I) position, it switches On the HV to the pump 1 if the
controller is set for LOCAL/REMOTE I/O operation and the external and HV
Cable interlocks are closed
It is On when the controller is supplying the HV to the pump 1.
It is flashing in case of Fault (see paragraph "Technical Information" for
details)
When in ON (I) position, it switches On the HV to the pump 2 if the
controller is set for LOCAL/REMOTE I/O operation and the external and HV
Cable interlocks are closed
It is On when the controller is supplying the HV to the pump 2.
It is flashing in case of Fault (see paragraph "Technical Information" for
details)
When in ON (I) position, it switches On the HV to the pump 3 if the
controller is set for LOCAL/REMOTE I/O operation and the external and HV
Cable interlocks are closed
It is On when the controller is supplying the HV to the pump 3.
It is flashing in case of Fault (see paragraph "Technical Information" for
details)
It allows to select the operating mode:
SERIAL: all the commands are given through the serial line
LOCAL-REM I/O: all the commands are given through the unit front panel
or through the 25 pin REMOTE connector on the rear panel
Installation Procedure
Use
4
71/101
Publicité
Chapitres
