idrania OPTIMA PRO NEXT 200 Manuel D'installation page 16

Paragraph 10 – Setting the Maximum Flow Rate
Programming
+
PROG
Config.
Config.
Funct.
Language
English
Max Flow
P100%
Paragraph 11 – Flow Rate Calibration
Programming
+
PROG
Config.
Pump Cal
0.25cc/l
Pump Cal
Manual
Pump Cal
Auto.
Paragraph 12 – Statistics
Programming
+
PROG
Config.
Stats
Hours
Hours
0
Strokes
0
Q.ty (L)
L 0
Power
1
Reset
Stats
Hours
EM00136320
Max Flow
P100%
Max Flow
F160s/m
cc/s
0.25
Cal.Auto
Start
cc
25
Reset?
Yes
Allows you to set the maximum flow rate of the pump and
the programmed mode (% or frequency) is used as the
standard measurement unit when displaying the flow rate.
Press to access the item, and then press
the value. Press
menu.
On the main menu appears the memorized cc/stroke value.
You can perform the calibration in two modes:
MANUAL – insert manually the cc/stroke value using the
key and then confirm with the
AUTOMATIC – the pump runs 100 strokes, which are
started by pressing the
strokes insert the amount aspirated by pump using the
key and confirm with the
The data entered will be used for the calculation of the flow
rates.
On the main menu is displayed, in hours, the operating time
of the pump; press
- Strokes = the number of strokes performed by the pump
- Q.ta (L) = the quantity dosed from the pump expressed in
liters; this information is calculated based on the memorized
cc/stroke value
- Power = the number of pump activations
- Reset = press
(NO), then press
Press to return to the main menu.
rev.2.0 EN
Operation
to confirm and return to the main
Operation
key.
key, and at the end of the
key.
Operation
to access other statistics:
to reset the counters, select (YES) or
to confirm.
to set
14