Paragraph 5 – Proportional to External Impulses (division)
Programming
+
PROG
Config.
Config.
Funct.
Funct.
(n:1)
n
1
Paragraph 6 – Proportional to External Impulses (batch dosage)
Programming
+
PROG
Config.
Config.
Funct.
Funct.
(1:c)
Q.ty
1
ml
Time
10
s
Memory
Off
EM00136320
Display during operation
Function mode
1:n (n set)
•
Alarms and statuses
Lev = Level Alarm
•
Flw = Flow Alarm
empty = pump in stating
•
•
Stop = pump in stop
•
•
Paus = pump in pause
•
The pump doses proportionally to an external signal (ex: water meter
pulse-sender). For every "n" signals received, the pump runs a stroke. The
"n" value can be set during programming. By programming the "n" value,
you set the % of maximum dosage; during operation this value can be
modified by pressing
Display during operation
Function mode
n:1 (n set)
•
Alarms and statuses
Lev = Level Alarm
•
empty = pump in stating
Flw = Flow Alarm
•
•
Stop = pump in stop
•
•
Paus = pump in pause
•
The pump doses proportionally to an external signal (ex: water meter
pulse-sender). In this case, you can set the quantity to be dosed in
mL and the period of time necessary to complete the dosage.
The dosage can be started manually by pressing
remote command.
You can press
made can be reset to zero by pressing
The quantity to be dosed can be modified during operation by
pressing
1:n
P 100%
Value of dosing on going
(depends on unit of measure
Pump status
Percentage, Frequency,
•
l/h, Gph, ml/m
•
+
n:1
P 100%
Value of dosing on going
(depends on unit of measure
Pump status
Percentage, Frequency,
•
l/h, Gph, ml/m
•
to interrupt the dosage. The dosage already
again.
+
simultaneously to modify the flow rate.
rev.2.0
EN
selected)
Operation
simultaneously.
selected)
Operation
or restarted by pressing
or through a
9