Care And Maintenance; Maintenance; Cleaning; Storage - Metabo SPA 1200 Instructions D'utilisation Originales

working machine has been turned
OFF.
3
Note:
For extended daily use of your wood-
working machine an automatic power
relay for the dust extractor would be of
advantage This relay turns the dust ex-
tractor time-delayed ON and OFF once
the woodworking machine is turned ON
or OFF respectively.
This automatic power relay is available
from the manufacturer in two versions
(see chapter "Available Accessories").
6.

Care and Maintenance

A
Danger!
Prior to all servicing:
1. turn the machine OFF,
2. unplug,
3. wait until the machine has come to
a complete stop.
– Repair and maintenance work oth-
er than described in this section
should only be carried out by quali-
fied specialists.
– Replace defective parts, especially
of safety devices, with genuine re-
placement parts only. Parts not test-
ed and approved by the manufac-
turer can cause unforeseen
damage.
– Check to see that all safety devices
are operational again after each
service.
6.1

Maintenance

Before switching ON
Visual check to see if power supply ca-
ble and power cable plug are damaged;
have faulty parts replaced by a qualified
electrician.
The machine requires no maintenance.
However, before switching ON perform
the following checks.
Check all screw connections!
•
Retighten loose connections.
Is the switch housing, motor or fan
•
housing damaged? Have these
parts immediately replaced by a
qualified electrician.
Is the upper dust bag or suction
•
hose damaged? Replace the dam-
aged part(s).
6.2

Cleaning

Wipe work stand and fan housing
•
with a moist cloth.
Motor and ON/OFF switch may only
•
be cleaned with a dry cloth.
The upper dust bag should only be
•
beaten (make sure dust collection
bag is installed on the underside of
the machine).
Change the chip collection bag
•
when it is about 4/5 full.
6.3

Storage

For storing the dust extractor, place
•
the suction hose over the motor and
insert the end in the opening in the
base plate.
A
Danger!
Store the machine in such way that
•
it can not be started by unauthor-
ised persons.
Make sure that nobody can get hurt
•
by the stored machine.
A
Caution!
Do not store machine unprotected
•
outdoors or in damp environment.
6.4

Repairs

A
Danger!
Repairs to electric tools may only be
carried out by a qualified electrician!
Electric tools in need of repair can be
sent to the Service Centre in your coun-
try. Refer to the spare parts list for the
address.
ENGLISH
Please attach a description of the fault
to the electric tool.
7.

Available Accessories

For special tasks the following accesso-
ries are available from specialist retail-
ers:
A Automatic power relay
order number: 0913014626
ALV 1, single-phase 230 VAC,
for time-delayed switch-on or
switch-off of the dust extractor after
the woodworking machine has been
switched on or off.
B Automatic power relay
order number: 0913014634
ALV 10, three-phase 400 VAC, sin-
gle-phase 230 VAC
C Filter cartridge
order number: 0920016529
filters out ultrafine dust particles,
effective filter surface 52 m
D Chip collection bag
order number: 0913017617
8.

Disposal

Power tools should not be
disposed of with household
waste. According to Europe-
an directive 2002/96/EC on
waste electrical and elec-
tronic equipment used pow-
er tools must be collected separately
and taken to an appropriate recycling
facility.
Contact your local council for the dis-
posal options for your old tool.
The tool packaging is 100% recyclable.
2
13