Tension Force; Recommended Tension Force; Adjustment Lock; Setting The Tension Force Via The Adjustment Dial - HellermannTyton EVO9 Manuel D'utilisation

Tension force

7 Tension force
The tension force that the application tool uses to pull on the cable ties can be set using the
adjustment dial (Figure
5
Quick adjustment (Figure I and J )

7 .1 Recommended tension force

The following formula can be used as guideline for the recommended tension force on the
application tool.
Minimum tensile
strength
2
The minimum tensile strength is the force that the cable tie can withstand before it deforms or
tears (see cable tie technical specifications).

7 .2 Adjustment lock

NOTE
The quick adjustment is possible even when the adjustment lock is activated.
The adjustment lock prevents unintentional adjustment of the tension force.
f Using a T8 Torx screwdriver, unscrew the screw
position .
2
f Screw the screw

7 .3 Setting the tension force via the adjustment dial

The tension force is selected in N (Newton) using the tension force scale.
Setting (tension force scale)
Tension force EVO9/
EVO9SP in
Tension force EVO9HT in
f Press the thumb lever
this position.
f Using the adjustment dial
f Let go of the thumb lever.
The tension forces specified are only general reference values. Due to the diversity of possible
influences during processing and use, we recommend to check the tension cut off forces with a
conventional force meter (frequency of the data recording should be at least 10 kHz).
6
).
A
= recommended tension
force
back in front of the thumb lever in position
1
0 1
53 89
120 156
(Figure ) to the front in the direction of the arrow and hold it pressed in
3 A
, set the desired value on the tension force scale
5
Operating Instructions • EVO9 | EVO9SP | EVO9HT • 11-2015 • 031-93351
(Figure ) of the adjustment lock from
1 C
(Figure
2
2 3 4 5
111 138 169 200
196 245 298 356
).
D
6 7 8
240 276 307
418 467 516
.
4