Technical Information - Maxx Ice MIM250 Manuel D'utilisation, D'installation Et D'entretien

• Except to take ice from the unit, keep the door closed in order to reduce ice melting and to
promote proper ice formation
• Although the unit has been tested at the factory, due to long-term transit and storage, the first
batch of cubes must be discarded
• If the ice maker will not be used for a long time, before the next use it must be thoroughly
cleaned Follow carefully any instructions provided for cleaning or use of sanitizing solution Do
not leave any solution inside the ice maker after cleaning
• DO NOT touch the condenser fins. The condenser fins are sharp and can be easily damaged.
• DO NOT use solvent-based cleaning agents or abrasives on the interior These cleaners may
transmit taste to the ice cubes, or damage or discolor the interior
• The ice machine cleaner contains acids DO NOT use or mix with any other solvent-based cleaner
products Use rubber gloves to protect hands Carefully read the material safety instructions on
the container of the ice machine cleaner
• Do not use this apparatus for other than its intended purpose
SAVE THESE INSTRUCTIONS
Electrical Connection
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord
For personal safety, this appliance must be properly grounded The power cord of this appliance
is equipped with a 3-prong grounding plug that mates with a standard 3-prong grounding wall
outlet to minimize the possibility of electric shock hazard from the appliance Have the wall outlet
and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When
a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet
The ice maker should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance This provides the best performance and
also prevents overloading house wiring circuits which could cause a fire hazard from overheated
wires. Never unplug your ice maker by pulling on the power cord. Always grip the plug firmly and
pull straight out from the outlet Repair or replace immediately all power cords that have become
frayed or otherwise damaged Do not use a cord that shows cracks or abrasion damage along its
length or at either end When moving the ice maker, be careful not to damage the power cord
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you
do not use an extension cord with this ice maker

Technical Information

Model:
Electrical input:
Power consumption:
Ice-making/Ice-harvest rated current:
Refrigerant:
High/Low side pressure:
Unit width x depth x height:
Unit weight:
Ice storage capacity:
Ice-making capability:
Ice shape:
Ice cube dimensions:
Ambient temperature range for best operation:
Optimum temperature range for feed water:
*The actual quantity of ice produced per day can vary with room and water conditions
The technical data and performance index listed above should be used for reference only
They are subject to change
SERVICE AND INSTALLATION MANUAL
www.maxxfoodservice.com
MIM250
115VAC ~ 60Hz
9 55 kW·h /100 lbs of ice
9 2A/12A
R404a, 22 9 oz
350psig/190psig
24" x 24" x 39"
136 lbs maximum
75 lbs maximum
200 lbs/day*
Cube
1" x 1" x ¾"
50°F – 100°F
41°F – 90°F
4