Leveling The Ice Maker; Water Supply - Maxx Ice MIM250 Manuel D'utilisation, D'installation Et D'entretien

Ice Maker Installation

LEVELING THE ICE MAKER

Once the ice cube machine is set in its
enclosure, if the base is not level, you
can adjust the feet by rotating the under
block (see below) until the machine is
level
It is important for the ice maker to be
leveled, or water may not flow properly
through the evaporator (ice mold) Ice
production will be lower than normal,
and operation will be noisy
Adjust the height of the under block of the adjustable foot, rotating it to the right (counter- clockwise)
to lower that side of the ice maker Turning the under block to the left (clockwise) raises that side of
the ice maker

Water Supply

The water supply should be ready at the point of installation The water supply pressure should be a
minimum of 15 psig with a static pressure not more than 80 psig (A wall outlet directly behind the ice
maker will make installation easier )
We strongly recommended the use of a water filter. A filter, if it is of the proper type, can remove taste
and odors as well as particles and can prolong the life of the machine
IMPORTANT:
1 All installations must be in accordance with local plumbing code requirements
Professional installation is recommended
2. Water inlet fitting: 3/8" FPT (Female Pipe Thread); drain line connection: 1/2" FPT.
3 Make certain you have a suitable water supply hose and two suitable drain hoses, and that the
hoses are not pinched, kinked or damaged during installation
4 Check for leaks after connection
Tools required: 3/8" open-end wrench, Phillips screwdriver
Connecting the water line:
1 Turn off main water supply
2 Find a water supply line near the installation location The distance should be less than the length
of the water supply hose
3 A shut-off valve must be installed to the main water supply
4. Connect the water supply hose to tap and water inlet valve. Tighten firmly by hand, then one-half
turn with wrench
5. Connect one water drain hose to ice maker drain line connection. Tighten firmly by hand, then
one-half turn with wrench
6. Connect another water drain hose to bin drain line connection. Tighten firmly by hand, then one-
half turn with wrench
7 Turn on main water supply and tap Check for water supply connection leaks Tighten every
connection (including connections at the water inlet)
NOTE: If using a water filter, be sure to follow the filter manufacturer's directions.
9
Under block
Turning the under block
counter-clockwise reduces
the machine's height up
Turning the under block
clockwise increases the
machine's height