Selecting The Correct Helmet Size; Maintenance And Care; Storage; Disposal Instructions - Crivit Sports 78791 Notice D'utilisation

Selecting the correct
helmet size
• Choose your helmet by measuring the cir-
cumference of your head with a flexible tape
measure . Always try on a couple of different
sizes before buying a close fitting helmet .
When wearing the helmet, the skin of your
temples should ideally move with it .
• Make sure that the helmet does not move
around when the retention system is open .
• The retention system must be set securely. The
chinstrap must sit comfortably under the chin
as far back towards the neck as possible.
Fasten it as tight as possible . The right degree
of tension is reached once you find it difficult
to insert your finger between the chinstrap and
neck, yet finding it easy to breath and swallow.
Make sure that the helmet sits securely once
the retention system is on. Make sure that the
helmet does not restrict your movements, e .g .
when turning your head to look behind you.
• Make sure the helmet carries a sticker certify-
ing homologation .
Size table
Size Head circumference
M
L
XL
57 – 58 cm
59 – 60 cm
61 cm

Maintenance and Care

Regular maintenance and care contributes to
safety and maintaining the helmet .
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet .
• Only use water and pH balanced soap.
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e .g . dead insects, dirt, sand, dust etc )
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth .
• When the visor gets wet (e.g. rainwater) it
should always be wiped with a soft cloth .
• When cleaning the visor, never use any petro-
leum-based solvents or detergents containing
abrasives .
Cleaning of the Cheek Pads,
Acoustic Pads and Inside Pads
• Hand wash below 30 °C.
• Allow to dry at room temperature.
• Avoid sources of heat.
• When not in use, store in a dry, well ventilated
place .

Storage

When not in use, store the helmet in a dry and
well ventilated place at room temperature .
Avoid sources of heat . Do not needlessly expose
the item to heat, e .g . in the car in hot outside
temperatures .

Disposal Instructions

Dispose of the product and all its components
through a licensed disposal company or your
municipal disposal facilities . Please observe the
current regulations . If in doubt, consult your dis-
posal facility about an environmentally friendly
disposal .
GB 15