Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo HT-R980 Manuel D'instructions

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote
control code.
1
While holding down REMOTE MODE that you
want to reset, press and hold down AUDIO until
the remote indicator lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that
the button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down AUDIO until the remote indicator lights
(about 3 seconds).
2
Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that
the remote controller has been reset.
En
62

Controlling Other Components

By pressing REMOTE MODE that's been programmed
with the remote control code for your component, you can
control your component as below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ 61).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV receiver via HDMI. If controlling your TV via
p doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV receiver via HDMI.
*1
The p supported by the
system control function of the HDMI standard.
*1
(limited to
*1
is the CEC
AV receiver