Pre Rec; Post Rec; Copy To Camera; Network Menu - urmet domus 1093/061S Guide Rapide

In this mode, recording starts as soon as a sensor detects an alarm.
In this mode, recording starts as soon as either a sensor detects an alarm or a motion is detected.
In this mode, recording starts as soon as either a sensor detects an alarm and a motion is detected.
In this mode, recording starts when the "REC" button is pressed.
Press "REC" to stop the recording again.
2.3.1.9

Pre REC

The recording will contain the video feed prior to the alarm for the set time in the event of a motion detection or external alarm
event.
Possible options are: "Nr.", "5s", "10", "15s", "20", "25", "30" and "Max".
Use "▲▼" to select.
Select "Nr." for no "pre-recording".
2.3.1.10

Post REC

The recording will contain the video feed following the alarm for the set time in the event of a motion detection or external alarm
event.
Possible options are: "5s", "10", "30s", "1Min", "2Min", "5Min" and "10Min".
Use "▲▼" to select.
2.3.1.11

Copy to camera

Select "Copy to camera" to select on which cameras to copy the following settings:
•
resolution
•
bit rate
•
frame rate
•
enable rec - schedule
Select "all" to copy the settings on all cameras. Select "Copy" and press "ENTER" to copy the settings. Confirmation of the
operation will be required: press "ENTER" again to confirm.
2.4

NETWORK MENU

Description
Use this menu to configure the DVR according to the parameters of the Ethernet network to which it is connected.
Position the "Active Frame" on the "NETWORK" icon and press "ENTER".
IMPORTANT NOTE
The default IP address of the DVR is: 192.0.0.64. Use this menu to assign to the DVR an IP address which is not used
in the network by other devices to prevent conflicts.
Connect the DVR to the network after having correctly configured the IP address.
The following window will appear:
DS1093-022
Alarm
Motion / alarm
Motion & alarm
Command
Figure 28: network menu (basic settings)
41