OHAUS T21P Manuel D'instructions page 12

EN-10
4. SETTINGS
4.1 Menu Mode and Navigation
To enter the Menu Mode
Press and hold the SET button for 3 seconds.
SET-F
[ x] will be displayed where x =:
0= set upper and lower limit value.
1= User Settings Menu.
2= restores settings to factory default.
3= set tare capacity between 2/3Max. and full scale.
To navigate in the Menu Mode:
Press
Press ENTER to accept the displayed setting and advance to the next step.
Press SET at any time to save settings and return to weighing.
4.2 Set Upper and Lower Limit Values
Enter the Menu Mode (Section 4.1). [
Press ENTER to accept the displayed setting and view the upper limit [000000].
The Over LED will illuminate.
Press , ,
Press ENTER to confirm the setting and display the lower limit [000000].
The Under LED will illuminate.
Press , ,
Press ENTER to confirm the setting and the display will show the alarm setting
rUn
[ X], where x=:
0 = check weigh mode is disabled.
1 = under / accept / over LEDs are active, the beeper will sound when the weight
is outside the accept range.
2 = under / accept / over LEDs are active, the beeper will sound when the weight
is within accept range.
3 = under / accept / over LEDs are active, the beeper is disabled.
Press to change the alarm setting.
Press ENTER to confirm setting and display the upper limit.
Press SET to store the values and return to weighing.
Calle 23B No. 81A - 62 Modelia PBX: (571) 410 28 48 Fax: (571) 263 72 24 Bogota, D.C. - Colombia.
www.tecnipesaje.com
to toggle through available settings.
to edit the upper limit.
to edit the lower limit.
tecnipesaje@tecnipesaje.com
SET-F0
] will be displayed.
T21P Indicator
tecnipesaje@outlook.com