Electra HYDRIVE Manuel Du Propriétaire page 17

Display unit
Technical data
Item
Operating
temperature
Storage
temperature
Degree of
protection
Weight (approx)
2.3 Operation
Requirements
The e-Bike system can only be activated
when the following requirements are met:
- A sufficiently charged battery pack is
installed (see battery pack operating
instructions).
- The display unit is correctly connected
and installed on the handlebar.
Initial settings
1. Turning the E-bike system On
Options for switching on the e-bike system:
- Press the power button on the display
when the bicycle battery is installed.
- Press the power button on the battery pack.
Once the e-bike system is switched on, the
system will default to the "off" mode; select
the desired assist level using the up and
down arrows and start riding.
When you stop pedaling, or if your speed
reaches 20 mph, the assistance provided by
the e-bike will stop automatically; when you
start pedaling again, the drive unit assistance
Specification
14°F~104°F
(10°C~+40°C) 80%RH
-4°F~140°F
(-20°C~+60°C) 80%RH
IPX5 (dust and splash
water protected)
0.08 lb /35 g
will automatically resume if the riding speed is less
than 20mph.
2. Turning the E-bike system Off
Options for turning off the e-bike system:
- Press the power button on the display unit.
- Press the power button on the battery pack.
After pressing the power button, the system will
shut down; this takes approximately three seconds.
You must wait until shut down is complete before
you can turn the e-bike system on again. If the
e-bike is not used and no buttons are pressed, the
e-bike system will automatically turn off after six
minutes to save power.
Note:
- Please turn off the e-bike system after riding.
- If the display unit's internal battery is empty, you
can still use the power button on the battery to
turn on the e-bike system.
However, it is suggested that you replace the
internal battery as soon as possible in order to
avoid any damage to the e-bike system.
3. Power display / Charge level
The battery condition of the e-bike
battery will be displayed on the display.
4. Using the walk assistance mode
The walk assistance mode can help you push your
e-bike more easily with a maximum speed of up
to 4 mph.
” This mode can only be enabled when you are
pushing the bike.
When using the walk assistance mode, and if the
bicycle is not in contact with the ground, there is
a the risk of severe injury.
15
EN - 5