Installation Settings - JVC KW-NT30 Manuel D'instructions

Installation settings

When you turn on the unit for the first time, the initial
setup screen appears.
1
Turn on the ignition switch.
The power is turned on, and the startup screen is
displayed for about 5 seconds.
2
Select the language you want for the display
and the voice guidance.
• You can also select the system language through
the AV menu (<Settings> - <System> -
<Language>, ☞ page 68).
3
Display installation settings screen.
• If you select [Skip Installation Settings (for
Store Display)], the System starts in the store
display mode.
You need to make the installation settings next
time you turn on the power.
– When you turn on the power, <Select
Language> appears. After selecting
the language, the confirmation message
appears. Press [Yes] so that the System starts
initialization. When initialization is complete,
<Select Language> (☞ Step 2 above) is
displayed.
4
Adjust the settings.
Country Select the country where you are
now.
Time Zone * Select your residential area for
automatic clock adjustment by
GPS signal.
Summer Select <Auto> if your residential
time * area is subject to Summer time.
Reverse Select the reverse signal polarity
Signal (<Battery> or <GND>)
Polarity * according to the connection of
your car.
Camera Select <On> when connecting
Input * the rear view camera to the
CAMERA IN jack.
* You can also change these settings through the AV
menu (<Settings>, ☞ page 68).
5
To cancel the display demonstration, ☞ page 67
(<Demonstration>).
9