Jofel SECAMANOS AVE AA18 Serie Manuel D'instructions page 15

EN
INSTALLATION AND ASSEMBLY
B-
cable to connect the power supply to the unit. for the hand dryer, pass it
through hole C in figure 1 and secure it in place to the device's junction box.
Note:
The size of the cable must be 2x1.5mm².
Use a cable that complies with national standards. (Use the HO5RN-F
cable).
Mark 4 points on the wall and drill Ø8mm holes, place the plugs and then
fix it in place the unit using the screws supplied as shown in figure 3.
IMPORTANT:
A multi-pole disconnector with a contact gap of 3 mm must be incorporated into
the installation.
The equipment must be installed at a minimum distance of 0.6 m from distance
from a water point (sink, etc.).
Replace the housing cover in the direction of the arrows and screw on.
Tighten screws A and B in figure 1 firmly.
When the power supply is far away from the unit, use a flexible
Pag.6
D